Per-Stem Editor

What it is

Load your song as separate stems and the Track Mixer gives each one its own mini studio. Click Edit on any stem to open a full-screen editor with its waveform and a complete channel strip, so you can finish each part before it sums into the master instead of fighting the whole mix at once.

The channel strip

• High-Pass filter to clean rumble and mud from the bottom of a stem
• 3-band EQ (Low, Mid, High) for quick tonal shaping
• Mid/Side EQ to treat the centre and the sides separately: de-mud the centre, add air to the sides
• Character saturation with Tube, Tape, and Clip modes plus Drive and Mix, for analog warmth and glue on raw stems
• De-Esser to tame harsh sibilance on vocal and cymbal stems, with tunable Frequency, Threshold, and Range
• Compressor with full Threshold, Ratio, Attack, and Release
• Stereo Pan and Width to place and size each stem in the image

Built for a fast workflow

Every stem shows a live level meter and a gain-reduction readout, so you can see what each part is doing while it plays. Dial in one stem, then copy its settings and paste them onto another to start from the same place. When you are done, Bounce to Master renders every stem through its own chain exactly as you hear it, so what you preview is what you export.